Goochain’s Angola Red dual tablet POS stand brings a deep burgundy finish to the checkout counter. Two opposing tablet holders and a dedicated card reader arm share an aluminum base, with two USB connections and internally routed leads for the tablets. Configure the device holders, cables and finish around your store layout and approved sample.
Goochain’s dual tablet POS charging stand lets staff enter orders on one tablet while shoppers review the order and pay at the reader beside the customer display. Both tablet mounts share one freestanding base. Two built-in USB ports and internal routing for the tablet leads keep separate chargers and loose cables off the checkout surface in the reference setup. Device fit and power configuration are agreed for each project.
Goochain develops multi-bay charging stations for payment readers that remain inside approved protective cases. Each project defines the complete reader-and-case assembly, bay guides, pickup clearance, charging interface and simultaneous device quantity. Station geometry, cable modules, indicators and branding can be customized. Bay count and power requirements are confirmed for the approved configuration; this is an OEM/ODM development solution rather than a universal charger for all readers or cases.
Goochain manufactures custom contact and cable assemblies for card reader docks. Each interconnect combines a project-approved reader-side or dock-side interface with the required cable termination, mounting support and strain relief. Contact layout, conductor mapping, cable length and any signal requirements are defined from authorized project information. The contact-and-cable subassembly can be supplied separately for integration into the customer's housing; full docks and power accessories are included only when quoted.
A Pogo Pin does not make a dock reliable by itself. The contact has to meet the device pad at the right position, working stroke and pressure while the housing guides the device into place. Power design, cable routing and production tolerances are part of the same result.
Goochain develops custom docks as complete mating systems. The device or protective case, contact board, cradle, guide surfaces and power input are reviewed together before tooling.

Guide surfaces, ribs, tapers or magnets should bring the device onto a repeatable datum. The contact pins should not be used as alignment posts. Side loading can damage pins, wear pads and create intermittent charging.
The nominal design should keep each pin within an approved compression range after part and assembly tolerances are included. Too little compression risks unstable contact; excessive compression increases force and wear. Goochain reviews the full tolerance stack rather than only the nominal drawing.
Pin quantity, parallel power contacts, conductor size, PCB copper, connector and adapter must support the required system current and temperature limit. Data functions need their own channel review. Charging and data claims are validated against the approved configuration.
Fixtures should confirm contact position, continuity, charging and fit. Reliability plans may include repeated docking, cable strain, contact resistance monitoring and environmental checks according to the project. Goochain records the sample revision and test conditions so a result is not applied to unrelated versions.

For a custom dock, send Goochain the device sample, contact pad drawing, charging/data requirement and expected use cycle. These inputs allow the mechanical and electrical design to be closed together.