Goochain’s Angola Red dual tablet POS stand brings a deep burgundy finish to the checkout counter. Two opposing tablet holders and a dedicated card reader arm share an aluminum base, with two USB connections and internally routed leads for the tablets. Configure the device holders, cables and finish around your store layout and approved sample.
Goochain’s dual tablet POS charging stand lets staff enter orders on one tablet while shoppers review the order and pay at the reader beside the customer display. Both tablet mounts share one freestanding base. Two built-in USB ports and internal routing for the tablet leads keep separate chargers and loose cables off the checkout surface in the reference setup. Device fit and power configuration are agreed for each project.
Goochain develops multi-bay charging stations for payment readers that remain inside approved protective cases. Each project defines the complete reader-and-case assembly, bay guides, pickup clearance, charging interface and simultaneous device quantity. Station geometry, cable modules, indicators and branding can be customized. Bay count and power requirements are confirmed for the approved configuration; this is an OEM/ODM development solution rather than a universal charger for all readers or cases.
Goochain manufactures custom contact and cable assemblies for card reader docks. Each interconnect combines a project-approved reader-side or dock-side interface with the required cable termination, mounting support and strain relief. Contact layout, conductor mapping, cable length and any signal requirements are defined from authorized project information. The contact-and-cable subassembly can be supplied separately for integration into the customer's housing; full docks and power accessories are included only when quoted.
A clean counter is the visible benefit of cable management. The less visible benefit is reliability. A protected cable is less likely to be pulled, pinched, twisted or disconnected when the stand moves and the device is serviced.
Goochain plans cable routing during the mechanical concept stage. This allows the stand, enclosure, connector and custom cable to support each other instead of competing for the remaining space.

Confirm connector orientation, insertion space and the direction the cable naturally leaves the device. Right-angle, up-angle or down-angle connectors may reduce the envelope, but the correct direction depends on the actual installation.
Swivel, tilt and flip stands change cable length and bend. The route needs enough controlled slack without creating loops that catch on the base. Rotation stops or slip-ring solutions may be considered according to the required movement and electrical architecture.

The connector should not carry pulling force from the external cable. Clamps, overmolds, channels and anchor points transfer load to the structure. Internal short cables need the same attention around reader modules and docking contact boards.
Cable covers and hidden channels should open in a defined sequence. Goochain reviews whether the cable can be replaced without removing the tablet, base or unrelated electronics, and whether the correct part can be identified by a label or keyed connector.
Provide Goochain with the device ports, stand movement and installation cable route. We can develop the cable assembly and mechanical protection together for a cleaner, more maintainable POS product.