Goochain’s Angola Red dual tablet POS stand brings a deep burgundy finish to the checkout counter. Two opposing tablet holders and a dedicated card reader arm share an aluminum base, with two USB connections and internally routed leads for the tablets. Configure the device holders, cables and finish around your store layout and approved sample.
Goochain’s dual tablet POS charging stand lets staff enter orders on one tablet while shoppers review the order and pay at the reader beside the customer display. Both tablet mounts share one freestanding base. Two built-in USB ports and internal routing for the tablet leads keep separate chargers and loose cables off the checkout surface in the reference setup. Device fit and power configuration are agreed for each project.
Goochain develops multi-bay charging stations for payment readers that remain inside approved protective cases. Each project defines the complete reader-and-case assembly, bay guides, pickup clearance, charging interface and simultaneous device quantity. Station geometry, cable modules, indicators and branding can be customized. Bay count and power requirements are confirmed for the approved configuration; this is an OEM/ODM development solution rather than a universal charger for all readers or cases.
Goochain manufactures custom contact and cable assemblies for card reader docks. Each interconnect combines a project-approved reader-side or dock-side interface with the required cable termination, mounting support and strain relief. Contact layout, conductor mapping, cable length and any signal requirements are defined from authorized project information. The contact-and-cable subassembly can be supplied separately for integration into the customer's housing; full docks and power accessories are included only when quoted.
POS HARDWARE · ENGINEERING GUIDE
A payment reader may move between handheld use and a counter dock several times during service.
The return step should be specified as an operating sequence, not only a fitting check. Goochain develops reader docking hardware and helps customers define the mechanical and connection requirements for that sequence.

Identify whether the reader is in use, idle or disconnected before it leaves the dock. Record the exact reader, host device and accessory configuration. If communication is required, name the supported method and the customer software environment. A charging-only dock has a narrower task than an accessory involved in a wired connection.
The sequence should also state which cable or case remains with the reader. Removing a complete fitted assembly can have a different result from disconnecting an exposed plug.
First check that the returned device reaches its intended position without a second manual adjustment. Then observe whether the approved charging connection is established. A well-seated reader does not prove that the electrical path is complete, and a visible light does not necessarily identify which part of the path is active.
Repeat the agreed sequence in the allowed placement positions. Record the source and the device state so an intermittent observation can be investigated rather than dismissed as a user error.

Where a project needs data, the host and application must be part of the review. Check what the system reports after removal and return, and whether an additional user step is intended. Any requirement for recovery time should be agreed by the customer system team and measured in the relevant configuration.
Do not attribute software pairing, host permissions or application behavior to the dock housing. Hardware development can support a defined interface, but it does not replace the reader manufacturer’s integration requirements.
Goochain combines reader fitting, custom cable assemblies, connector integration and accessory assembly for OEM/ODM projects. With more than 10 years of manufacturing experience, our team can review how the return routine affects the supplied hardware and its production checks. Goochain Charging Dock for NYC1 Readers is one reader-specific accessory example; OEM & ODM Solutions for POS Accessories explains the project support scope.
Send the reader, host and expected removal-and-return routine to goochain@goochain-tech.com. A clear sequence makes the accessory requirement easier to evaluate and the accepted behavior easier to explain to the deployment team.

Goochain manufactures this accessory. Reader brands and model names identify the intended device only; no authorization or endorsement by the reader brand owner is claimed.